How to setup ADAM (Modbus)

1. Plug in the cable to the correct port.
   1. (Y) Data+ and (G) Data (modem) and RS485 cable to the laptop
   1. (R)+Vs and (B) GND 10 (Power)

• With the module powered off, turn the switch in the “Init” position.
• Power Up the module
• Wait 10 seconds for the module to initialize.
• Open the ADAM Software and check device manager on which COM port the Adam device is plugged in. Right click on the port and click search device and click Start

• Once the device appears below the com port, click cancel.
• Go Module Setting and change the setting to the following:

• Double click on Adam device and click Data Area. Change the Input range to 4~20 mA

• Update the settings by pressing the “Update” button.
• Power off the module.
• Turn the switch back to the NORMAL* position. (For the older Adam models, remove the wire between the INIT* and GND terminals)

• The module is now ready to be placed in the Modbus network.
• Setup the Modem (See Instructions on how to setup Modem)
• Add the device to Collect Live Data
• Go to the Adam and click Poll.Check the Status and confirm that it is communicating.